Jump to content

pattern transfer


magnus homestead

Recommended Posts

Hi there,

 

There seemed so much interest and so many different ideas expressed in Antonio's post as to methods of transfering a drawing or design from paper to the object (wax in this case) that I thought I'd start a new thread.

 

I have arrived at using templates cut from my paper with a scapel to trace around on wax to do relief carvings - I think it's easier than trying to work through the paper with needle holes or the like. Here are some photos that show what I mean.

 

What is your method?

And when going into 3D ( in the round ) do you have special ways for that?

I have been drawing on boxwood, carving and then drawing some more as I go - seems to work, but I just haven't been able to spend enough time to progress very far in that medium.

 

Magnus

post-239-1219457750.jpg

post-239-1219457781.jpg

post-239-1219457826.jpg

post-239-1219457870.jpg

Link to comment
Share on other sites

  • 3 weeks later...
Hi there,

 

There seemed so much interest and so many different ideas expressed in Antonio's post as to methods of transfering a drawing or design from paper to the object (wax in this case) that I thought I'd start a new thread.

 

I have arrived at using templates cut from my paper with a scapel to trace around on wax to do relief carvings - I think it's easier than trying to work through the paper with needle holes or the like. Here are some photos that show what I mean.

 

What is your method?

And when going into 3D ( in the round ) do you have special ways for that?

I have been drawing on boxwood, carving and then drawing some more as I go - seems to work, but I just haven't been able to spend enough time to progress very far in that medium.

 

Magnus

 

 

I do about the same thing as what you do Magnus. Except that when I'm working on something that starts out flat, I tape my pattern to it with clear shipping tape to secure it while cutting around or through my paper pattern. For things I want to use more than once, you can add another layer of tape to lift it off for future use, even if it's got small pieces. With 3D stuff, I tend to pattern cut the outlines, then draw and cut like what you described. If I must use a pattern on a curved or wavy surface, I sometimes wet the paper first, and wind a piece of string round it till it dries, then use tape as usual.

LJ

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...