Jump to content

Low Relief Hardstone Carving

Pete D

Recommended Posts

Hello everyone.

I haven't posted for quite a while but have been busy with many things. If I may share with you my first attempt at very low relief hardstone carving (less than 1/3 mm).

It's Zebra stone (around 6.5 mohs) and was cut so that the brown and white bands were parallel then the main features were carved with burrs then I used scrapers to try to get varying shades of colour. The whole thing is about 50mm wide

Any comments or suggestions are welcomed.

Thanks for looking


Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...